Meiji Techno TC5000 Series Bedienerhandbuch PDF herunterladen (Seite 34)

5.3 Replacing the 6V 30W Halogen Light

ALWAYS DISCONNECT YOUR EQUIPMENT BEFORE DOING ANY REPAIR.

Do not touch the glass envelope of the lamp during installation. Keep the protective

sleeve or bag of the lamp during installation and remove it right after installation.

LAMP AND LAMP HOUSING MAY BE HOT TO THE TOUCH.

• Switch off the microscope.

• Disconnect the power cord.

• Wait until the housing and

bulb have cooled sufficiently.

• Simply turn the illuminator

cover counterclockwise and

lift to remove.

• Remove the defective lamp.

• Place a new lamp into the

socket while avoiding

touching the glass. Notice the

bulb is wrapped in plastic to

avoid touching the glass

envelope.

• Be sure the bulb is pushed in

as far as possible thereby

aligning the filament in the illuminator.

• Reinstall the lamp housing making sure the notches on the housing and the cover

are lining up.

• Reconnect the power cord and switch on the microscope to verify proper

illuminator operation.

1 2 ... 29 30 31 32 33 34 35 36 37 38 39 40 41 42

Keine Kommentare

Meiji Techno TC5000 Series Bedienerhandbuch Seite 34